Griffin PowerMate Quick Start Guide
(Version 2.0)
The Griffin PowerMate USB tuning knob is an excellent way to control either the SDR-1000 or the
Flex-5000 using the PowerSDR software. Below are instructions detailing how to get the PowerMate
to work with the PowerSDR software.
Figure 1 -- Griffin Powermate USB Control Knob
If you already have the PowerMate software installed and running, skip to the section called “Setup
PowerMate for PowerSDR”.
Download Latest Software
Go to the following URL and download the latest software from Griffin Technologies:
http://www.griffintechnology.com/support/products/powermate
Save the file and run it to begin the driver installation.
You should see the following dialog:
Figure 2 – License Agreement Dialog
Check the box accepting the License Agreement and click on “Next”.
To Next Page
Need help?
General