Grill'D Aurora Series

Questions and Answers

J
Jeffrey SchultzJul 29, 2025
Why is my Grill'D Aurora Heater not heating up my sauna room?
- J
  James LaneJul 29, 2025
  Several factors could be at play. The sauna room might be too large for the heater's capacity. Also, the thermal insulation of the room might not meet the necessary requirements. Check that the heater capacity matches the size of the sauna and the thermal insulation complies with requirements. Insufficient chimney draft, low quality or wet combustion material, or a blockage in the chimney or flue channels of the heater can also be causes. Perform maintenance and check combustion material for compliance.
S
stacy16Aug 6, 2025
How to fix stones in Grill'D Aurora Heater that don't heat up?
- Y
  ydelacruzAug 6, 2025
  Several factors can cause this problem. The sauna room might be too small for the heater's capacity, causing the room to heat up faster than the stones. Also, there might be insufficient chimney draft, low quality or wet combustion material, or a blockage in the chimney or flue channels. The stones may be laid incorrectly, or there can be stone chips. Check that the compliance of the heater capacity against the sauna size. Remove stone chips and replace them with intact stones. Replace the stones with diameters less than the ones specified in Table 1 with larger ones.
D
deanna91Aug 13, 2025
What to do if smoke enters the sauna when using my Grill'D Aurora Heater?
- A
  Allison LivingstonAug 13, 2025
  If smoke is entering the sauna, several issues could be the cause. There might be a blockage in the chimney or flue channels, so perform maintenance. The chimney height might be insufficient, or it's located near a high obstacle; consider extending the chimney stack. Cold air in the chimney could also be a factor; insulate the chimney stack with a non-combustible heat-insulation material. Check combustion material for compliance with the requirements, as low quality or wet material can cause this issue. Finally, the chimney might be installed incorrectly; ensure it meets the manufacturer’s requirements.
C
Carolyn VillaAug 20, 2025
Why does my Grill'D Heater smell during operation?
- N
  Nicholas BowersAug 20, 2025
  Odors during heater operation can arise from a couple of sources. There might be leftover industrial oil on the heater surface, or the odor could be coming from the heat-resistant enamel. Also, when heating up, the heater can enhance odors already present in the air, even if they don't originate from the sauna or the heater itself.

Summary

General Data

Operation Manual

Safety Measures

Consult your doctor and pediatrician about health-related limitations and suitability for children.

Heater Design and Operation

Details on overall view, location of main elements, and internal design.

Heater Commissioning

Procedure for preheating the heater before initial operation to evaporate protective coatings.

Combustion Material

Approved and recommended fuel types, along with prohibited materials.

Stones for Stone Heater

Guidelines for selecting, cleaning, and placing stones in the heater.

Heater Operation

Instructions on ensuring a clean firebox and chimney before heating.

Water in the Sauna

Requirements for tap water quality and precautions when pouring water onto stones.

Maintenance

Routine cleaning of chimney, heater, and parts for efficient and safe operation.

Typical Faults and Troubleshooting Methods

Identifies common issues like odors and provides troubleshooting steps.

Installation Manual

Before Commencing Installation

Ensuring safety distances, local rules compliance, and individual chimney stack.

Configuration of Sauna Ventilation

Details on self-ventilation and mechanical exhaust ventilation setups.

Sauna Floor Protection

Guidance on protecting concrete, tiled, or combustible floors during installation.

Safety Distances

Specifies minimum distances from heater to ceiling, flammable materials, and walls.

Heater Installation

Ensuring proper floor levelling and precluding heater/chimney slants.

Stone Chimney Connection

Details on connecting the heater to a stone chimney stack.

Heater Connection to a Steel Chimney

Procedure for connecting the heater to a steel chimney system.

Warranty

Appendix 1. Heater Dimensions

Aurora mini Short

Dimensional drawings and specifications for the Aurora mini Short model.

Aurora mini Long

Dimensional drawings and specifications for the Aurora mini Long model.

Aurora 160 Short

Dimensional drawings and specifications for the Aurora 160 Short model.

Aurora 160 Long

Dimensional drawings and specifications for the Aurora 160 Long model.

Aurora 160 Window

Dimensional drawings and specifications for the Aurora 160 Window model.

Aurora 160 TRIO Short

Dimensional drawings and specifications for the Aurora 160 TRIO Short model.

Aurora 160 TRIO Long

Dimensional drawings and specifications for the Aurora 160 TRIO Long model.

Aurora 160 TRIO Window

Dimensional drawings and specifications for the Aurora 160 TRIO Window model.

Aurora 180 Short

Dimensional drawings and specifications for the Aurora 180 Short model.

Aurora 180 Long

Dimensional drawings and specifications for the Aurora 180 Long model.

Aurora 180 Window

Dimensional drawings and specifications for the Aurora 180 Window model.

Appendix 2. Heater Structural Elements

Appendix 3. Internal Design and Operation of Heaters

Appendix 4. Heater Parts Installation

Grate

Description and installation of the grate, consisting of 6 separate plates.

Ash Drawer

Details on the place of installation and method for the ash drawer.

Combustion Chamber Reinforcement

Procedure for installing the combustion chamber reinforcement plates.

Decorative Screen

Note and procedure for installing the decorative screen.

Door Mini and Short;Long

Instructions on mounting firebox doors for mini and Short/Long models, including opening direction.

Door Window

Procedure for installing the firebox door for Window models, including mounting side and angle.

Appendix 5. Delivery Packages