Need help?Do you have a question about the Grillo Climber 710 and is the answer not in the manual?
General| Blades | 1 |
|---|---|
| Weight | 228 kg |
| Engine | Briggs & Stratton |
| Engine Type | 4-stroke |
| Cutting Width | 70 cm |
| Cutting Height Adjustment | Central |
| Grass Collection | Yes |
Machine's serial number is on the steering column label.
Manual covers basic maintenance; contact dealer for other operations.
Use original spare parts and quote serial/code numbers when ordering.
Guarantee provided by law; engine/battery conditions apply manufacturer terms.
Check for transit damage, oil levels, tyre pressure, and battery voltage.
Change engine oil and filter after first 5 working hours. Check for leaks.
Sit, set levers, use choke if cold, turn key, warm up engine.
Turn on headlamp after engine starts to avoid battery discharge.
Choose cutting height, accelerate engine, engage PTO, operate travel lever gently.
Engage by lifting loop and hooking lever; adjust using register.
Avoid straining engine, don't leave in rain, sharpen blades, check land, keep grilles clean.
Adjust deck height with lever; 4 positions (35-80mm) + travel position.
Follow engine handbook for intervals; change oil/filter at specified hours/season.
Check expansion tank, clean cooling fans, replace oil at intervals.
Grease pivot pins and lubricate steering joints every 20 hours.
Check air filter every 4 hours or more in dusty environments.
Sharpen blades, check tightness, use original blades, check bolts.
Ensure levelness for even cut; adjust 4 devices.
Check/adjust belt if twisted/off; care with belt guides.
Belts are self-adjusting; check spring tension, release to replace.
Start/stop blade with switch; engine at medium rpm; clutch brakes blade on disengagement.
Belts transmit movement; replace worn belts; complex procedure, use service center.
Located at back; move to idle for towing/moving by hand.
Dashboard OFF; check cables, recharge battery, change fuse.
Dashboard ON; recharge battery, check levers, disengage blades, check safety sensors.
Carburation problems, deposits in fuel; clean filter, adjust carb, empty tank, check filter.
No petrol flow, faulty ignition; check choke, petrol level, filter, vent cap, spark plugs.
Reduce speed or raise cutting deck.
Reduce speed or raise cutting deck.
Check tyre pressure, deck level, blade mounting, sharpening, belt tension.
Check blades are correctly mounted, sharpen or change them, check belt tension.
Blades unbalanced or fastenings loose; balance blades, fasten screws.
To Next Page