Translation of the original instructions
TOWING THE MACHINE WITH SWITCHED OFF ENGINE
Attention! To move the machine with the engine switched off undo by two turns the screw on the hydrostatic pump
(fig. 35); pay attention because doing so the efficiency of the self-braking device is cancelled. Tow the machine at
very low speed and only on small distances, maximum 100 metres, to avoid seizing the hydraulic pump or
engine.
STORAGE AND LACK OF USE FOR LONG PERIODS
Store the machine in a dry environment, sheltered from bad weather conditions and, if possible, covered up. Clean
the machine from grass residues. If the machine is to be out of use for more than 30 days, detach the red cable
from the battery and follow the engine manual instructions. Remember to lubricate all the joints. Regularly check
that the battery voltage does not go under 12,5 Volts. If it is below, recharge the battery
MAINTENANCE SUMMARY TABLE
PROCEDURE EVERY
8 HOURS
AFTER
20 HOURS
EVERY
50 HOURS
EVERY
100 HOURS
ONCE A
YEAR
OR EVERY
250 HOURS
Engine oil Check the level
•
Change
•
(first change)
•
Air filter Check
•
Replace *
Hydraulic oil Check the level
•
Replace *
(first change
after 500
hours)
Check that the cooler intake grid is
clean
•
Check that blades are well
sharpened and well-fixed
• •
Lubricate with grease
•
Diesel filter Check
•
*
Replace
•
Deck gearbox Replace
•
P.T.O. gearbox Replace
•
Diesel decanting device Check
•
Clean
•
• recommended procedure
* procedure to be carried out if necessary
IMPLEMENTS
LIFTING HOOKS AND TRANSPORT
The hooks location (fig. 38) allows the machine with its cutting deck to be perfectly balanced. Only lift the machine
with suitable equipment such as crane etc. When transporting the machine on a truck put the putting deck in a low
position and secure the machine with the correct straps or chains.
15
To Next Page
Loading...
Need help?
General
