- 2 -
INTRODUCTION:
THANK YOU, for your purchase of the Groove Tubes Variable
Transconductance Glory Compressor.
Please read over this manual carefully as it contains
information essential to the proper operation and maximum
enjoyment of this dynamics controller.
The Glory Compressor is designed to provide suitable
downstream dynamics processing when paired with the GT VIPRE,
or any other professional audio source, and furnish maximized
sonic performance coupled with a generous ability to wrap
itself around the dynamic content of any signal source you may
wish to transform.
With the Glory Compressor’s feature compliment, you no longer
have to settle for what a given audio signal sounds like with
a low-headroom solid-state dynamics controller, or be boxed-in
by limited side-chain control options.
The Glory Compressor is designed to be flexible, and to adapt
to accommodate your situation, rather then the other way
‘round. To this end you will notice that it is the
anticipation of your compressor applications, which has driven
every detail of the Glory Compressor’s planning, engineering,
feature set, operating convenience and adaptability.
UNPACKING
Unpack the compressor carefully and make sure that all
supplied accessories are present. Examine all items for any
possibility of shipping damage. All seven tubes should be
standing at attention in their sockets. If the compressor is
damaged or fails to operate, notify the shipper and your
dealer or us immediately. Or if the compressor was shipped to
you directly, notify the shipping company without delay.
Your Glory Compressor was packed with the following
accessories:
A. 1 each rack-mount bracing kit.
L/R pair of rack mounting braces, which can be attached to the
sides of the Glory chassis, and rack mounted I RU above the
Glory front panel. This brace provides both rear chassis
To Next Page
Loading...