Page 1
Specication
The Janus C4 2-Door Blade is a plug-in unit that can
be purchased with either the Janus C4 Single-Blade
Controller (Part No: JC4-ADV-C2-SNG) or the Janus C4
Multi-Blade Controller (Part No: JC4-ADV-C2-MLT).
Each 2-Door Blade enables the connection of two readers
and two doors in Janus C4 access control systems.
Clearly labelled connectors simplify the task.
Overview
Janus C4 2-Door Blade
Lock Switching Capacity
12V/24V, 4A max (Solid State output, current limited)
Card Reader interface
Wiegand, Clock/Data, RS485
Card Reader Supply, power limited
12V 500 mA, 5V 200 mA total (both ports)
Tamper, Door Sensor, Exit Switch, Aux, Inputs
5V pullup (2k2), max 12V in
Break Glass Input
24V max
Sounder, Valid, Invalid Output
500 max sink to GND (solid state), 12V max in
Aux Out
Isolated 30V, 300mA max, internally fused
External Lock Input Supply
24V max, 8A max. Must be externally fused
Operating Temperature
0 to +49°C (32 to 120°F)
Humidity
5-85±5% at 30±2°C (86±4°F)
Weight
140 g
Dimensions
197 x 60 x 28 mm
Janus C4 2-Door Blade
Installation Guide
C4
JC4-ADV-BL-2D
Electromagnetic Compatibility
This product complies with the following standards,
following the provisions of EMC Directive 2014/30/EU:
EN 55022:2010 Class B
EN50130-4:2011 inc A1:2014
IEC 62599-2:2010
WEEE
Please refer to www.grosvenortechnology.com/
legal-info/ for disposal instructions under EU Directive
2012/19/EU.
Part number:
To Next Page
Need help?
General
