Growatt ARK 2.5H-A1 Quick Installation Manual

ARK 2.5H-A1
Quick Installation Manual
Installation environment
Max.
+50℃
Min.
-10℃
RH.
+5%~+95%
Installation tools
System size
1.Check
Check ARK 2.5H-A1 List
1-2
ARK 2.5H-A1 X1
Serial cable X1
Check HVC60050-A1 List
1- 1
HVC60050-A1 X1
Warranty card X1
Quick installation Manual X1
Power cable ( to battery) X1
Plug X1
Diagram of wiring connection
5-3
Note:
1、Before installing the system, ensure that the voltage difference of the battery pack is less than 0.5V；
2、For the same system, it is recommended to select the battery with the manufacturing date difference within 3 months,
otherwise the system capacity will be limited.
3、If there is a switch between PCS and battery, it is recommended to use a circuit breaker with rated voltage greater than
750V and rated current greater than 63A.
To PCS
Insert Plug
To PCS
Insert Plug
ARK 2.5H-A1 Series cable
ARK 2.5H-A1 cable
Battery+Battery-
CAN
PE
CAN
Battery- Battery+
PE
6.Terminal Connection
Power terminal
6-1
Communication terminal
6-2
1
8.Service and contact
Shenzhen Growatt New Energy Co., Ltd
86 0755 2747 1942
Growatt New Energy
6
5
HVC60050-A1
ARK 2.5H-A1
Power ON battery system
Power OFF battery system
a、Power on battery system：
Turn the circuit breaker to the "on" state,
then press the "POWER" button for 5-6 seconds,
and wait until the LED of the battery system lights up,
indicating that the power on is completed
7.Battery system switch operation
ARK 2.5H-A1 Connection end face introduction
5-2
1 2 3 4 5 6 7
Wir
e si
de
W
i
re s
id
e
b、Power off battery system:
Turn the circuit breaker to "off" to turn off the
entire battery system
4-13/F,Building A,Sino-German(Europe) Industrial Park,
Hangcheng Ave, Bao'an District, Shenzhen, China
1
Communication input
5
Ground terminal
2
Communication output
6
Pressure relief valve
3
Module negative
terminal
7
Ground terminal
4
Module positive
terminal

Growatt ARK 2.5H-A1 Specifications

General

Brand	Growatt
Model	ARK 2.5H-A1
Category	Battery Pack
Language	English