Growatt MOD 9000TL3-X - Page 166

Error code
Description
Suggest
Error 413
IGBT drive fault
1. Restart inverter.
2.If error message still exists,contact manufacturer.
Error 414
EEPROM fault
1. Restart inverter
2.If error message still exists, contact manufacturer.
Error 41 5
In te r na l po wer
test fail(PV Power
low)
1 .Restart inverter.
2.If error message still exists,contact manufacturer.
Error 41 6
O v e r c u r -
r e n t p r o -
t e c t e d b y
software
1. Restart inverter.
2.If error message still exists,contact manufacturer.
Error 41 7
The grid voltage
sampling is incon-
sistent
1 .Restart the machine;
2.If the fault information still exists,contact the manufacturer.
Error 418
DSP and COM firm-
ware version un-
match
1.Check the firmware version.
2.If error message still exists,contact manufacturer.
Error 41 9
Inconsistent leak-
age current sam-
pling
1 .Restart the machine;
2. If the fault information still exists,contact the manufac-
turer.
Error 420
G FC I M o d u l e
damage
1: After shutdown,Check the leakage current module 2: If the
error message still exists, contact manufacturer
Error 421
CPLD is abnormal
1. Restart inverter.
2.If error message still exists,contact manufacturer.
Error 422
s a m p l i n g i s
inconsistent
1. Restart inverter.
2.If error message still exists,contact manufacturer.
Error 425
AFCI self-test fault
1 .Restart inverter
2.If error message still exists, contact manufacturer.
43