Growatt ShineLink-X Quick Installation Manual

Tip 1: Add new ShineRFSck device
Note:
Only aer reseng ShineLanBox or adding a new ShineRFSck-X, you need to pair ShineLanBox and
ShineRFSck-X, all the devices will be paired by the manufacturer.
Quick press ShineRFSck-X (in less than 2 seconds), then quickly press ShineLanBox’s buon, you can
enter pairing mode, at this point, the ShineLanBox’s pairing light is ashing, ShineRFSck-X ’s Blue
light is ashing quickly if the pairing is successful, ShineLanBox’s pairing light is o, ShineRFSck-X
’Blue web light change to slow ashing. (the light is on for one second, and o for a second.)
Note: The longest connecon distance between ShineLanBox and ShineRFSck-X should be no more
than 200 meters, if there is a wall between ShineLanBox and ShineRFSck-X the longest connecon
distance is 50 meters, if there
are two walls between ShineLanBox and ShineRFSck-X the longest connecon distance is 20 meters.
Tip 2: Reset ShineLanBox
Purpose of reseng collector:
(1 ) Erase all the pairing records
(2 ) ShineLanBox IP changes to Automac
Steps of reseng collector:
Press the ShineLanBox buon for more than 6 seconds, unl all four LED lights are on, then release
the buon, at this me all the sengs have been erased. Aer reseng because of the need to
repair ShineLanBox and ShineRFSck-X, please refer to Tip 1 above.

Growatt ShineLink-X Specifications

General

Brand	Growatt
Model	ShineLink-X
Category	Measuring Instruments
Language	English