M
moorebrianJul 28, 2025
How to avoid 'Username existing' error in Growatt Measuring Instruments?
- AaspencerJul 28, 2025
To avoid the username existing, use your email address as the username during registration.
To Next PageTo Next Page
How to avoid 'Username existing' error in Growatt Measuring Instruments?
To avoid the username existing, use your email address as the username during registration.
What to do if datalogger already exists in Growatt ShineWiFi-X Measuring Instruments?
If a datalogger already exists, navigate to 'Plant' in Shinephone and find 'Datalogger List'. Click and hold the datalogger you added previously, then click on 'Configure datalogger' to reconfigure. If the datalogger is not listed, contact Growatt.
Why is my Growatt ShineWiFi-X dongle light not flashing blue or solid green after Shinephone configuration?
If the dongle's light doesn't flash blue or show solid green after configuration in Shinephone, reset the dongle until it flashes red, then repeat the configuration process.
What to do if I don't know the Growatt ShineWiFi-X Measuring Instruments installer code?
If you do not know the installer code, leave the field blank and proceed, or contact your installation company.
General| Model | ShineWiFi-X |
|---|---|
| Communication Type | WiFi |
| Frequency | 2.4 GHz |
| Compatibility | Growatt Inverters |
| Interface | USB |
| Monitoring Platform | ShineServer |
| Operating Temperature | -20°C to 60°C |
Locate LED indicator, reset button, and barcode on RS232 dongle.
Locate LED indicator, QR code, and reset button on USB dongle.
Reset the dongle to achieve a solid blue LED status for setup.
Connect smartphone to the WiFi network broadcast by the dongle.
Open a web browser and input the dongle's IP address to log in.
Set the dongle to connect to the home WiFi network in manual mode.
Restart the dongle and check LED for successful connection to home WiFi.
Follow guide to register the dongle with ShinePhone account.
Growatt contact details for support and inquiries.
