7
Make sure retaining tabs
are fully pushed out and
seated properly.
Cap O-ring should be
tight and smooth.
Make sure O-ring is in-
stalled as shown and free
of damage.
Pressure off is counter-
clockwise.
HELPFUL TIPS
• Replace nitro gas cartridge after every use. Any remain-
ing gas can be used to flush your uKeg with clean water
(see Cleaning on page 5).
• Long term storage of your uKeg with a cartridge in-
stalled will reduce cartridge seal life. Remove cartridges
promptly after discharge.
• The cartridge seal is designed to be resilient, but may be
damaged from overtightening or sharp cartridges. Your
uKeg came with 1 extra cartridge seal, and more can be
purchased at: GrowlerWerks.com
• The cap o-ring is designed to be resilient, but may be-
come damaged or loose from over-tightening.
• Replacement cap seals are available at:
GrowlerWerks.com
OPTIONAL: Applying a light coat of silicone grease to
o-rings will extend their lifetime. Available at:
GrowlerWerks.com
Helpful Tips
INSPECT PERIODICALLY
To Next Page
Loading...