GrowlerWerks uKeg Nitro - Cleaning Your uKeg; After Each Use Cleaning; Thorough Cleaning Procedure

5
CLEANING YOUR UKEG
• Turn off gas.
• Remove cap and
rinse with warm
water. (less than 120
degress F).
1 . 3 .
• Discharge remaining
nitro gas by turning
dial and venting.
• Remove and recycle
gas cartridge.
4 .
• Fill with warm water
under 120 degress F
and 1 cleaning tablet.
• Cap and shake well.
• Baking soda is a
suitable substitute.
• Install cap, charge
briefly with left-over
nitro gas, flow water
through tap and
close tap.
• Let sit 10 minutes.
• Open tap until
pressure runs out.
• Remove the nozzle
for cleaning and
drying.
• Rinse (make sure
parts inside nozel
remain intact).
• Allow to dry
by pouring out
remaining water.
• Store with cap off
and tap open in dry
place.
5 .
uKeg
Cleaning Tablets
Available At
GrowlerWerks.com
1 . 2 . 3 .
AFTER EACH USE
FOR A MORE THOROUGH CLEANING
• Install cap.
• Use remaining nitro
gas to flow water
through tap.
• Close tap.
• Rinse uKeg with
warm water.
• Repeat 2-3 times
until clean.
2 .