What to do if my Grunbeck WINNI-mat VGX Water Dispenser shows Er 4?
If your Grünbeck Water Dispenser displays error code Er 4, this indicates a low salt level. Check the salt level in the brine tank and refill with salt tablets as per EN 973 type A if needed. After refilling, wait 5 minutes and then acknowledge the error.
Why does my Grunbeck Water Dispenser show an error message after a power failure?
If your Grünbeck Water Dispenser shows an error message after a power outage longer than 5 minutes, it means the water softener is regenerating each exchanger after the return of power.
Why is there increased hardness in my Grunbeck WINNI-mat VGX?
If the blending or soft water from your Grünbeck Water Dispenser has increased hardness, it could be due to the water softener overrunning. Check the socket. You may need to contact Grünbeck’s technical customer service or an authorized service company. Also, check the setting of the blending valve and adjust it if necessary.
What does Er 3 mean on my Grunbeck Water Dispenser?
If your Grünbeck Water Dispenser displays error code Er 3, the water softener is currently in regeneration. This error message is self-acknowledging.
How to fix a Grunbeck WINNI-mat VGX Water Dispenser that does not suck brine?
If your Grünbeck Water Dispenser is not sucking brine, the water pressure may be too low. Increase the flow pressure to a minimum of 2.0 bar. Also, clean or replace the brine filling orifice.
What does Er 1 mean on my Grunbeck WINNI-mat VGX Water Dispenser?
If your Grünbeck Water Dispenser shows error code Er 1, this indicates a problem with the step time monitoring regeneration motor, possibly due to a defective motor connection cable or switch. Notify Grünbeck’s technical customer service or an authorized service company. Check the motor, cable, and switch.
Why is there resin in the outlet pipe of my Grunbeck Water Dispenser?
If your Grünbeck Water Dispenser has resin in the outlet pipe, it is likely due to a defective jet system. Notify Grünbeck’s technical customer service or an authorized service company.
What does Er 6 mean on my Grunbeck WINNI-mat VGX Water Dispenser?
If your Grünbeck Water Dispenser displays error code Er 6, the maximum contact at filling of the brine tank was not achieved. Notify Grünbeck’s technical customer service or an authorized service company. Check the brine valve, cable, and water inlet pressure.
What does Er 7 mean on my Grunbeck WINNI-mat VGX?
If your Grünbeck Water Dispenser displays error code Er 7, the minimum contact at salting was not achieved. Notify Grünbeck’s technical customer service or an authorized service company. Check the brine valve, cable, water inlet pressure, injector, and brine orifice.
Why does the brine valve in my Grunbeck Water Dispenser regenerate continuously?
If the brine valve of your Grünbeck Water Dispenser regenerates continuously, it may be due to an incorrectly adjusted, defective, or short-circuited switch. Notify Grünbeck’s technical customer service or an authorized service company.
Defines the intended purpose and scope of use for the water softener system.
Measures and warnings to prevent water damage to the installation site.
Highlights potential hazards like electrical, mechanical, and health risks.
Key technical data and performance characteristics of the water softener.
Specifies the intended uses and operational parameters for the water softener.
Preliminary steps and site preparation before installing the system.
Specific requirements and procedures for connecting the water supply.
Mandatory regulations and expert requirements for water softener installation.
Guidelines for connecting the system to the electrical power supply.
Step-by-step instructions for connecting the water supply and drain.
Guide to adjusting the system to achieve the desired soft water output.
Instructions for configuring essential system settings like time and hardness.
Procedures for annual servicing, often requiring professional assistance.
General| Brand | Grunbeck |
|---|---|
| Model | WINNI-mat VGX |
| Category | Water Dispenser |
| Language | English |
To Next Page
