English (GB)
31
Status
"Actual setpoint and external setpoint"
"Operating mode"
"Actual controlled value"
"Analog input 1, 2 and 3"
"Pt100/1000 input 1 and 2"
"Speed"
"Power input and power consumption"
"Operating hours"
"Replace motor bearings"
"Motor current"
R100 remote control
Installation Section Page
"Control mode" 10.4 "Control mode" 32
"Controller" 10.11 "Controller" (""Controller settings"") 37
"Signal relay 1 and 2" 10.9 "Signal relay" (""Relay outputs"") 36
"Buttons on product"
10.27 "Buttons on product" (""Enable/disable
settings"")
43
"Number" 10.22 "Number" (""Pump number"") 43
"Radio communication"
10.23 "Radio communication"
(""Enable/disable radio comm."")
43
"Digital input 1 and 2, Function" 10.7 "Digital inputs" 34
"Digital input/output 3 and 4, State"
10.8 ""Digital inputs/outputs"" 35
"Digital input/output 3 and 4, Function"
"Analog input 1, 2 and 3, Function"
10.5 ""Analog inputs"" 32"Analog input 1, 2 and 3, Measured parameter"
"Analog input 1, 2 and 3"
"Pt100/1000 input 1 and 2, Function"
10.6 ""Pt100/1000 inputs"" 33
"Pt100/1000 input 1 and 2, Measured parameter"
"External setpoint function" 10.13 ""External setpoint function"" 37
"Operating range" 10.12 ""Operating range"" 37
"Ramps" 10.16 "Ramps" 42
"Direction of rotation" 10.17 "Direction of rotation" 42
"Skip band 1"
10.18 "Skip band" 42
"Skip band 2"
"Motor bearing monitoring" 10.20 ""Motor bearing monitoring"" 42
"Motor bearings" 10.21 "Service" 43
"Standstill heating" 10.19 ""Standstill heating"" 42
To Next Page
Loading...
Need help?
General