Grundfos MGE 112 Series - Page 66

66 pages

To Previous Page

www.grundfos.com

98246988 0716

ECM: 1188065

The name Grundfos, the Grundfos logo, and be think innovate are registered trademarks

Main Page

Default Chapter2
- Table of Contents2
1 Symbols Used in this Document3
2 Abbreviations and Definitions3
3 General Description4
- Radio Communication4
- Battery4
4 Identification5
- Nameplate5
- Type Key6
5 Receiving the Product7
- Transporting the Product7
- Inspecting the Product7
6 Mechanical Installation7
- Handling the Product7
- Mounting7
- Cable Entries7
- Ensuring Motor Cooling7
- Outdoor Installation8
- Drain Holes8
7 Electrical Installation8
- Protection against Electric Shock, Indirect Contact8
- Cable Requirements9
- Mains Supply9
- Additional Protection10
- Functional Modules11
- Connection Terminals on Functional Modules11
- Signal Cables16
- Bus Connection Cable16
8 Operating Conditions17
- Maximum Number of Starts and Stops17
- Ambient Temperature17
- Installation Altitude17
- Humidity17
- Motor Cooling17
9 User Interfaces18
- Basic Control Panel18
- Standard Control Panel19
- Advanced Control Panel21
- Grundfos GO26
- R100 Remote Control30
10 Description of Functions32
- Setpoint32
- Operating Mode32
- Set Manual Speed32
- Control Mode32
- Analog Inputs32
- Pt100/1000 Inputs33
- Digital Inputs34
- Digital Inputs/Outputs35
- Signal Relay" (""Relay Outputs"")36
- Analog Output36
- Controller" (""Controller Settings"")37
- Operating Range37
- External Setpoint Function37
- Predefined Setpoints40
- Limit-Exceeded Function41
- Ramps42
- Direction of Rotation42
- Skip Band42
- Standstill Heating42
- Motor Bearing Monitoring42
- Service43
- Number" (""Pump Number"")43
- Radio Communication" (""Enable/Disable Radio Comm."")43
- Language43
- Date and Time" (""Set Date and Time"")43
- Unit Configuration" (""Units"")43
- Buttons on Product" (""Enable/Disable Settings"")43
- Delete History44
- Define Home Display44
- Display Settings44
- Store Settings" (""Store Actual Settings"")44
- Recall Settings" (""Recall Stored Settings"")44
- Pump Name" (Motor Name)44
- Connection Code44
- Run Start-Up Guide45
- Alarm Log45
- Warning Log45
- Assist45
- Assisted Pump Setup45
- "" (Assisted Motor Setup)45
- Setup, Analog Input46
- Setting of Date and Time46
- Setup of Multi-Pump System"" (Multimotor)46
- Description of Control Mode49
- Assisted Fault Advice49
11 Bus Signal49
12 Priority of Settings50
13 Grundfos Eye51
14 Installing a Communication Interface Module52
15 Identification of Functional Module54
16 Identification of Control Panel54
17 Changing the Position of the Control Panel55
18 Servicing the Product56
19 Cleaning the Product56
20 Signal Relays57
21 Megging58
- Inputs and Outputs59
- Identification Numbers62
- Electrical Connection63

Grundfos MGE 112 Series - Page 66

Table of Contents

Related product manuals