ENGLISH
36
USB OPERATION
---------------------------------------------------------------------------------------------------------------
Connecting external data media
Before connecting the external data medium it is
recommended to switch the television to stand-by
mode.
Before removing the external data medium,
the television set must be switched to standby,
so that no data loss occurs.
Notes:
7
The »USB2« socket of the television set
supplies a maximum power of 500 mA in
accordance with USB specifications. Exter-
nal hard disks which require more power
may therefore only be connected to the
»USB1« of the television set.
7
If you use a network cable for external hard
disks which are connected to the »USB1«
socket on the television, this network cable
must also be disconnected from the power
supply when the television is switched off.
7
External data media may not be disconnect-
ed from the television set while files on the
data medium are being accessed.
7
A bi-directional data transfer as defined for
ITE (Information Technology Equipment)
devices in EN 55022/EN 55024 is not
possible.
7
USB transfer is not in itself an operating
mode. It is only an additional function.
1 Press »8«, »1…0« or »P+« or »P-« to switch
on the television from standby mode.
2 Connect the »USB1« socket of the television
and the corresponding socket on the data
device (external hard drive, digital camera,
card reader or MP3 player) using a USB ca-
ble;
or
insert the USB plug of the USB memory stick
into the »USB2« socket of the television set.
Removing the external data
media
Before removing the external data medium, log
off the data medium.
1 Open the menu with »MENU«.
2 Select the menu item »USB« with »
V
« or
»
Λ
« and press »OK« to confirm.
3 Select the line »Safely Remove Disk« with
»
V
« or »
Λ
« and press »OK« to confirm.
Note:
7
The data medium can now be removed from
the socket.
To Next Page
Loading...
Need help?
General