Grundig 43 GFB 6621 - Searching for digital terrestrial TV channels manually

91
ENGLISH
7
If »

« (red) is pressed, the saved channels
will be deleted from the current channel list.
– The »Digital Searching« menu appears,
and the scan for TV channels begins.
– The search is complete as soon as the
message »Search is completed!« appears.
Note:
7
The search can be aborted with »EXIT«.
11 Switch to the Channel Editor with »

«
(yellow) ;
or
press »EXIT« to end the setting.
SETTING FURTHER CHANNELS
-----------------------------------------------------
Searching for digital terrestrial
TV channels manually
1 Open the menu with »MENU«.
2 Select menu item »Settings« with »
V «, » Λ «,
»
<
« or »
>
« and press »OK« to confirm.
3 Select the menu item »Source« with »
>
« or
»
<
« and press » V « to confirm.
– »Source« menu is active.
4 Select the line »Advanced« with »
V « or
»
Λ « and press »OK« to confirm.
5 Select the line »Active Antenna Power« with
»
V « or » Λ «.
Switch on the antenna power supply for the
antenna with »
<
« or »
>
« (»On«)
Important:
7
The antenna power supply (5V ) may only
be switched on if the antenna is an active
indoor antenna with a signal amplifier and
it is not already supplied with a voltage via
a mains plug (or similar supply). Otherwise
you may cause a short circuit and irrepara-
bly damage your antenna.
6 Press »BACK
<
« to go back one menu
level.
7 Select the line »Manual Channel Search«
with »
Λ « or » V « and press »OK« to
confirm.
8 Select the option »Air« with »
Λ « or » V «
and press »OK« to confirm
– »Manual Channel Search« menu is dis-
played.
9 Select whether to search for digital or ana-
logue TV channels.
To to this press »
Λ « or » V « to select the
option »Digital« or »Analogue« and confirm
with »OK«.
10 Enter frequency (3-digit) directly with
»1...0«.
– Search will start.
– The search is finished when the channels
found appear in the list.
11 Press »EXIT« to end the setting.