41
ENGLISH
TIMER MODE
--------------------------------------------------------------------------------------------------------------------------
Notes:
T
To set the second alarm time (»Alarm 2«)
repeat steps 5 to 10.
T
The setting for the alarm times 1 and 2 can
also be opened directly using the buttons
»AL1« and »AL2« on the remote control.
T
If no button is pressed for 10 seconds while
setting, the system will quit the process auto-
matically, and you have to start again.
11 Switch the device to standby by pressing »8«
on the remote control or »ON/OFF« on the
device.
– Display: Date, time and » « or » « with
the alarm time.
– The alarm sounds at the set time with the
alarm signal selected.
Interrupting the alarm
1 Press »S« while the alarm is sounding.
– Display: » « or » « flash.
– The alarm (signal tone or radio) stops.
Note:
T
The alarm will sound again depending on
how often a button has been pressed (1
time = after 5 minutes, 2 times = 10 minutes,
3 times = 15 minutes, 4 times = 30 minutes).
The total alarm time in 90 minutes.
Cancelling alarm stand-by
1 While the timer is sounding, press »AL1« or
»AL2«.
– If the timer is set to »Once«, the timer signal
stops and » « or » « disappears.
– If the timer is set to »Daily«, »Weekends« or
»Weekdays«, the timer signal stops and
» « or » « appear for the next day.
Activating and deactivating the
timer
1 Open the option »Alarm« using »AL1« and
»AL2« on the remote control.
– The »Alarm« menu appears.
2 Select the option »Enable« by pressing » « or
» « or by turning the Jog-Shuttle and confirm
by pressing »OK«.
3 To deactivate »Alarm 1« or »Alarm 2«, select
»Off« by pressing » « or » « or by turning
the Jog-Shuttle and confirm by pressing »OK«.
4 Select the option »Save« by pressing » « or
» « or by turning the Jog-Shuttle and confirm
by pressing »OK«.
– Display: » « or » « disappears.
Note:
T
To activate the alarm time, reselect the alarm
cycle in the »Cycle« menu and store it.
To Next Page
Loading...
