Why is the calc cleaning button blinking on my Grundig SIS 9180?
The calc cleaning button on your Grundig Iron is blinking because it is time for calc cleaning. You should perform the calc cleaning operation.
What to do if my Grundig SIS 9180 is not producing steam?
If your Grundig Iron is not producing steam, there might be a few reasons: * The water tank may be insufficient. Fill water into the water tank up to the MAX line. * Check if the water reservoir is installed in its housing. Also, the appliance does not provide steam if the temperature is set to “•” position. Adjust the temperature setting as “Smart-Hygiene mode, ••, ••• or MAX”.
How to prevent sediments from falling from my Grundig Iron?
If sediments and residues fall from the base of your Grundig Iron while ironing, it may be because the water you use is too calcareous. Fill the water reservoir by mixing tap water and drinking water for your next ironing operations.
What to do if my Grundig SIS 9180's on/off button is blinking?
If the on/off button of your Grundig Iron is blinking, the appliance may have switched to automatic power off mode. Press the on/off button to resolve this.
What to do if my Grundig SIS 9180 is dripping water?
If water drips onto the fabric while using your Grundig Iron, it may be because you pressed the steam trigger before the appliance reached the set temperature. The appliance is ready for ironing when the adjusted temperature is shown on the LED display.
How to clean stains on the base of my Grundig Iron?
If there are stains on the base of your Grundig Iron because wet clothes were ironed or scale stains have occurred, wipe the sediments and residues with a lightly dampened cloth after the appliance has cooled down adequately.
Why is my Grundig SIS 9180 Iron base not heating up?
If the base of your Grundig Iron is not heating, there may be a problem with the connection. Check the plug and the power cord of the appliance. If the appliance still does not operate although plugged in and the on/off button has been pressed, contact the authorized service.
How to fix unclear icons on the LED display of my Grundig SIS 9180?
If the icons on the LED display of your Grundig Iron are not clear, the protecting film on the LED display may still be on. Remove the protecting film.
To Next Page
General
