Grundig Sonoclock 490 - Alarm Mode; Radio Operation; Adjusting the Volume

ENGLISH
19
Alarm mode
Selecting the alarm times
The alarm stand-by (» « or » «)
must be activated.
1 Push the »AL 1 1+2 2« sliding
switch to »1« or »2«.
– Display: the »AL 1« or »AL 2«
LED glows;
or
activate both alarm times by plac-
ing the »AL 1 1+2 2« sliding in
the »1+2« position.
– Display: the »AL 1« and »AL 2«
LEDs glow.
Displaying the alarm times
Depending on the setting (»AL 1« or
»AL 2«) either alarm time 1 or alarm
time 2 is displayed.
1 Press »ALARM« and hold it
down.
– Display: the last alarm time set.
2 Release »ALARM« to end the dis-
play of the alarm time.
– Display: the current time.
Note:
7
If the »AL 1 1+2 2« sliding
switch is set to »1+2«, the alarm
times cannot be displayed.
OPERATION _____________________________________
Switching on and off
1 Press »RADIO ON« to switch on
the device.
2 Press » « to switch off (stand-by)
the device.
Radio operation
For the best FM (VHF) reception, it is
sufficient to direct the wire antenna
accordingly.
Tuning radio stations
1 Find and tune the station using
»- TUNING +«.
Adjusting the volume
1 Adjust the volume using
»+ VOLUME -«.
Adjusting the brightness of
the display
1 Increase the brightness of the dis-
play with »- DIMMER +«.
2 Decrease the brightness of the dis-
play with »- DIMMER +«.
Note:
7
Your device is equipped with
an automatically adjusts for the
brightness of the display.