Grundig Sonoclock 691 DAB+ - Programming FM radio stations - manually

21
ENGLISH
SETTINGS
---------------------------------------------------------------------------------------------------------------------------------------
Programming FM radio stations –
manually
1 To select FM radio as input source, press
»MODE SCAN ALARM« for a short time.
– Display: »FM«, then the name or the frequen-
cy of the FM radio station.
2 Open the menu with »MENU«.
3 Select the option »TUNE« with »+ VOL. -« and
press »SELECT/INFO« to confirm.
4 Press and hold down »+ VOL.« or »VOL. -« to
search the desired radio station.
– The automatic station search starts, and stops
at the next station with a strong signal;
or
briefly pressing »+ VOL.« or »VOL. -« until
you have found the frequency you want.
– The frequency changes in steps of 50 kHz.
5 To store the FM radio station on a preset, press
and hold down the required preset buttons »1«
to »5«, until »STORED« appears.
Press »+5« and the required preset buttons »1«
to »5« change for presets 6 to 10.
Note:
7
The device normally scans for FM radio sta-
tions which are strong enough to get good
reception. To scan radio stations with weak
signal:
Open the menu with »MENU«, select the
option »SCAN« with »+ VOL. -« and press
»SELECT/INFO« to confirm.
Select the option »DX« with »+ VOL. -« and
press »SELECT/INFO« to confirm.
Repeat the setting from point 2.
Setting the clock format
(12 or 24 hours)
1 Press »ON/OFF« to switch on the device.
– Display: e.g. »B5 AKT«.
2 Open the menu with »MENU«.
3 Select the option »SYSTEM« with »+ VOL. -«
and press »SELECT/INFO« to confirm.
4 Select the option »TIME« with »+ VOL. -« and
press »SELECT/INFO« to confirm.
– Display: »SET TIME«.
5 Select the option »12/24 HR« with »+ VOL. -«
and press »SELECT/INFO« to confirm.
– Display: »24«.
6 Select the desired clock format (12 or 24
hours) with »+ VOL. -«.
7 Press »SELECT/INFO« to confirm the setting.
8 Press »MENU« to end the setting.