Grundig STR 310 - Page 22

You must enter the following data:
The event number and day of recording. The number fol-
lowing the day stands for the week ( MON1 = monday
first week, MON2 = monday second week);
the start time in hours and minutes;
the stop time in hours and minutes;
the channel position.
Once you have set the times and channel for an event,
turn the event on by altering the OFF at the top of the
screen to ON with the Z\ or “7 key.
Press the key to store the setting.
Press the @ key twice to exit the menu.
The receiver indicates the timer is set by lighting a dot in
the front panel display.
The receiver must be in standby when the event time
arrives. The receiver automatically turns on, selects the
programmed channel and lights a second dot in the front
panel display to indicate the timer is in operation.
G) 21
It is sensible to set the receiver's event
timer to start a little before, and finish a
little after, the VCR timer to prevent recor-
ding the channel change.
The current time and day of the week is
displayed in the timer menu. If this is not
correct it must of course be reset as shown
earlier in this manual or the timer will not
operate at the correct time.
HINT
If you are using the receiver when the set
time arrives, the timer will be overriden and
not start the recording.