Grundig V 210 - Setting up and Connecting; Initial Setup and Power Connection; Speaker and Headphone Connections

If you want to set up your amplifier on a shelf, in a cabinet or
any other type of enclosure, always ensure that sufficient
ventilation is available.
Place the power supply cable as far as possible from the
sound signal lines in order to avoid disturbing signal interfe-
rence.
Important:
Always switch off the amplifier as well as any other connec-
ted auxiliary units before connecting or disconnecting speaker
connection cables.
When making connections, always note the identification
markings on the cables and sockets, as well as those on the
back of the unit, in order to avoid improper connections.
Improper connections can considerably impair sound quality.
Only connect the unit to a 230 V-, 50/60 Hz power source.
Always note the information on the unit’s rating plate as well
as on the back of the unit.
In order to take full advantage of your unit’s superior play-
back quality and overall performance, only quality speakers
with corresponding load ratings should be used. Speakers
should thus have an impedance of 4 to 162. Maxirnurn
amplifier output is achieved with 4Q speakers.
In addition, always make sure that speaker wires are properly
and tightly twisted to avoid protruding individual wires. These
can cause shorts.
Important:
In addition, proper speaker connection is also important for
quality sound. As seen from the listener, the right speaker
must be connected to the right terminal (right channel) and
the left speaker to the left terminal (left channel).
You can connect standard stereo headphones with a 6.3mm
headphone jack. Volume is adjusted with the rotary VOLUME
controller.
The arnplifier’s speaker outputs are automatically switched
off when the headphone jack is inserted, and are automatically
switched on again when it is removed.