16
Hazardous
live AC
Do not expose the unit to drip-
ping water or moist.
Placement:
Do not place your Atilla on top
of any heat producing products,
such as power amplifiers or
DACs. If you place the Atilla
inside any Hi-FI furniture or cab-
inets, there must be a clearance
of a minimum of 10cm (4 inch-
es) above the product and a
minimum of 5cm (2 inches)
along the sides. To allow a flow
of cooling air the back of the
cabinet must be open. If these
guidelines are not observed,
overheating may result.
Mains Switch:
To place your Atilla into standby
mode use the main switch. The
switch is located in the bottom
on the right side just beneath
the acrylic front panel.
SAFETY
INSTRUCTIONS
To Next Page
Loading...
Need help?
General
