What does 'CoDE07 Tare< 0!' mean on my GSE 675 Scales?
The 'CoDE07 Tare< 0!' error on your GSE Scales indicates a negative tare was attempted but is not allowed. For auto-tares, the GROSS Weight must be greater than zero unless P162 is changed to allow negative tares.
Why do my GSE Scales show 'CoDE11 WRONG CODE!'?
This error indicates that the incorrect access code was entered, thus preventing changes. To resolve this, enter the proper code or press the key alone to view selections without making changes.
What to do if GSE 675 display 'Code02 Under Load!'?
If the 'Code02 Under Load!' error appears on your GSE Scales, it could be due to excessive loading, in which case you should reduce the load. Otherwise, check the load cell connections. If a 4 wire load cell cable is being used, check that the sense jumpers are in place. Also, verify that the capacity selection P110 is correct; use the information parameters, especially P61103 and P61104, to check the setup and input signal.
What does 'tx abort' mean on my GSE 675?
The 'tx abort' message on your GSE Scales occurs if the key is pressed when the tx on hold error message is shown, or if P209 is set for abort and the transmit buffer becomes full.
How to troubleshoot CoDE85 Syntx Error on GSE Scales?
To troubleshoot a 'CoDE85 Syntx Error' on GSE Scales, re-check the macro or analyze the macro debug table to find out where the error occurred.
What should I do if my GSE 675 display 'CoDE95 SyErr HSR00'?
The 'CoDE95 SyErr HSR00' error on your GSE Scales indicates an error occurred at startup or during operation. Contact GSE.
What causes 'Entry >Max!' error on GSE 675 Scales?
The 'Entry >Max!' error on your GSE Scales is most likely caused by making an entry for an ID that is longer than the programmed size of that ID.
How to resolve Macro error on GSE Scales?
To resolve a 'Macro error' on GSE Scales, check for proper syntax. Analyze the macro debug buffer to help determine the cause of the error.
What does CoDE05 Zero> Max.! mean on GSE Scales and how to fix it?
The error 'CoDE05 Zero> Max.!' on GSE Scales indicates that the zero value is greater than the maximum. Use the key for subtracting off container weights. If a large dead-load is always present, apply this dead-load during the 'No Load?' prompt during calibration to permanently eliminate the offset.
What does 'CoDE81 Macro Stack' mean on GSE Scales?
This error indicates that the maximum number of macros pushed onto the stack has been exceeded. This usually means that macros are being invoked faster than they can be executed.
To Next Page
General