GST DI-9204E Installation And Operation

This document is subject to change without notice. Please contact GST for more information or questions.
Gulf Security Technology Co., Ltd.
No. 80,Changjiang East Road, QETDZ, Qinhuangdao, Hebei, P. R. China 066004
www.gst.com.cn www.utcfireandsecurity.com service.gst@fs.utc.com
DS1054854-1 Page 1
Connecting to the loop of GST fire alarm system,
DI-9204E Digital Manual Call Point (the MCP) is
suitable for public places. When there is fire,
pressing the action plate on the MCP can send
the alarm signal to fire alarm control panel. After
receiving the signal, the control panel will show
address information of the MCP and generate
alarm sound.
Features
 Electronically addressed by programmer
 Non-break-glass. Reset by a special key.
 Plug-in structure.
 Designed to comply with EN 54-11.
LPCB/CPD approved.
Wiring
Terminals on the MCP are shown as Fig. 1
Z1, Z2: Connecting to the loop of control panel,
polarity-insensitive.
Recommended Cabling
1.0mm2 or above fire cable, subject to local
codes.
Z1 Z2 Z1 Z2
Fig. 1
DI-9204E
Digital Manual Call Point
Application
1. Application of the MCP is shown in Fig. 2
Z2
Z1
Fire Alarm
Control Panel
MCP
to the next device
Z1 Z2 Z1 Z2
Fig. 2
2. The MCP should be programmed using
P-9910B programmer, shows in Fig.3. Please
refer to P-9910B Hand Held Programmer
Installation and Operation Manual.


Z2Z1 Z2Z1
Fig. 3
3. Usage of the key for reset
Vertically insert the key into the key-hole, push
in and turn clockwise. Turn the key back and
pull it out when the glass is rebounded, as
shown in Fig.4.

GST DI-9204E Specifications

General

Brand	GST
Model	DI-9204E
Category	Security System
Language	English