GST DI-9204E User Manual

30309264 Issue 1.03
Features
 Electronically addressed. The address can be
modified in field.
 Alarm by pressing, reset by a special key.
 Plug-in structure.
 Standard: EN 54-11.
Description
Connecting to the loop of GST fire alarm system,
DI-9204E Digital Manual Call Point (MCP) is suitable
for public places. When there is a fire, pressing the
frangible element on this MCP can send fire signal to
fire alarm control panel. After receiving the signal, the
control panel will show address information of the
MCP and generate alarm sound.
Connection and Cabling
Terminals on the MCP base are shown as Fig. 1（unit:
mm）.
Z1 Z2 Z1 Z2
Fig. 1
Z1, Z2: Connecting with loop of the control panel,
polarity-insensitive.
Recommended Cabling
0.5mm
2
or above fire cable, subject to local codes.
Installation
The MCP can be mounted in two ways: conduit
embedded and surface mounting.
Surface Mounting: First install the back box into the
wall using 4 screws, and then install the base onto the
back box. Connect cables to corresponding terminals
as described above. Hook the juts of the MCP body to
the base, and then press the part below the frangible
element to combine them completely, and then screw
the lock screw as shown in Fig. 2.
Conduit Embedded: First install the base onto the
back box, then connect the MCP body and the base
followed instructions above, then screw the lock screw
as shown in Fig. 3.
Back Box
Base
MCP Body
Lock Screw
Fig. 2
DI-9204E
Digital Manual Call Point
548g/08
0832-CPR-F0130
GST-0011-01
13
All manuals and user guides at all-guides.com
all-guides.com

GST DI-9204E Specifications

General

Brand	GST
Model	DI-9204E
Category	Security System
Language	English

Summary

Features

Description

Connection and Cabling

Recommended Cabling

Specifies 0.5mm² or above fire cable, subject to local codes.

Installation

Surface Mounting

Install the back box, then the base, connect cables, hook MCP body to base, press to combine, and screw lock.

Conduit Embedded

Install base onto back box, connect MCP body to base, then screw lock.

Specification

Application

Usage of the Key

Vertically insert the key into the key-hole, turn clockwise, push, turn back, and pull out when rebounded.

Compatible Equipment

Can be used with GST control panels such as GST200, GST200-2, GST200N, GST-IFP8.

Accessories and Tools

WEEE Information

Products marked with this symbol cannot be disposed of as unsorted municipal waste.

Limited Warranty