22
Fury Owner’s Manual Supplement
Technical Information
Changing Wheelbase Length
192927 Rev 0 (11/23)
1. Left dropout chip
2. Right dropout chip
3. Rear derailleur hanger
4. Screw
a. Dropout socket
Identification
Changing Wheelbase Length
The dropout chips can be installed for either a shorter or longer bicycle wheelbase. See
next figure, lower. The selected position of the chip in either the longer or shorter position
can be made independently of the positions of either the rear shock leverage or seatstay/
link chips.
Removal/Installation Points:
• Always clean the mounting hardware and frame interfaces with a clean dry lint-free
shop towel prior to assembly.
• Clean and re-grease the pockets where the chips are inserted. Also, lightly grease the
dropout and rear derailleur mating surfaces.
• Always re-apply threadlocker as indicated, and lightly grease under the bolt heads.
• Note that the rear derailleur hanger has alternative mounting bolt hole depending on
the flip chip position in use. See figure next, lower.
To Next Page
