31
Maintenance
Scheduling
MAINTENANCE
Any part of a poorly maintained bike can break or malfunction leading to an accident where
you can be killed, severely injured, or paralyzed.
Frequent checks are necessary to identify the problems that can lead to an accident.
See “Inspect For Safety” in your GT Bicycle Owners Manual.
Scheduling
The following table lists only supplemental maintenance items. Please consult your
GT Bicycle Owner’s Manual for more information on basic bike maintenance.
Item Frequency
Cable Routing - Make sure control cables are in place,
undamaged and attached securely.
Frame Protection - Check the various frame protectors on your
bike. Make sure they are in place and in good condition.
Before first ride
Damage Inspection - Clean and visually inspect entire bike
frame/swing arm/linkage assembly for cracks or damage.
Before and after each ride
Check Tightening Torques - In addition to other component-
specific tightening torques for your bike. tighten according to the
“Tightening Torques” information listed in this supplement.
Every few rides
Disassemble, clean, inspect, re-grease, replace worn or
damaged parts in the following assemblies:
• SHOCK LINK • PIVOT AXLES • FRAME PIVOT
BEARINGS
In wet, muddy, sandy
conditions every 25 hrs.
In dry conditions
every 50 hrs.
Fork and Shock- Consult the manufacturer’s owner’s manual for maintenance requirements.
To Next Page
