To Next PageTo Next Page
Need help?Do you have a question about the Guardall DTSx Plus and is the answer not in the manual?
General| Brand | Guardall |
|---|---|
| Model | DTSx Plus |
| Category | Security Sensors |
| Language | English |
Loosen only, do not remove.
Control for adjusting microwave range.
Screw for retaining the PCB.
Passive Infrared detector component.
Tamper switch for the unit cover.
Indicator for declination.
Light Emitting Diodes for status indication.
Connection point for off-the-wall tamper.
Block for electrical connections.
Designated positions for cable entry.
Required for EN Grade 3; screw in location A or C.
Diagram showing coverage in plan view up to 15m.
Diagram showing coverage in side view up to 15m.
Operating voltage range: 9 V to 16 V dc.
Quiescent: 14 mA; Max: 30 mA @ 12V.
Normally closed (NC) contacts, rated at 24 V dc, 50mA.
Positive supply to enable LEDs and control Remote Self Test.
Positive supply for system Set.
Adjustable via potentiometer from 50% to 100%.
Meets TS50131-2-4:2004, Grade 3, Class II with specific switch settings.
Guardall Ltd declares compliance with EU Directive 1999/5/EC.
For use within a building as an intruder detection device.
Power feed must be fused at 5A or less.
Recommended mounting height is 2.3m; ensure clear field of view.
Procedure for testing PIR and microwave coverage.
Selection of functions via DIP switches.
Enables or disables LED indications.
Enables pulse count detection in harsh environments.
Disables microwave when system is Unset.
Configures anti-masking and fault signaling.
Adjusts anti-mask sensitivity, set to OFF for harsh environments.
Enhances detection for high security applications.
Generates a test when TEST Input is taken high to low.
Memorizes alarms when System Set or Unset with SW1 OFF.
Occurs next time the system is set.
Defines LED behavior based on system state and switch settings.
Details on Red, Green, and Yellow LED behavior.
Covers defects in workmanship and materials.
