BEFORE OPERATING THE AIR PURIFIER:
1. Select a firm, level and flat location for the air purifier.
* For proper air flow, locate the unit at least 1 foot from any wall or furniture.
* Make sure none of the grills are blocked.
2. Plug the power cord into a 120V AC outlet.
IMPORTANT: When moving the air purifier, always lift unit by the carrying handle located
on back.
OPERATING THE AIR PURIFIER (AC5300 SERIES):
1. Turn unit power ON. To turn OFF, press and hold button for 3 seconds.
2. Select fan speed MODE 1 - 3
1 = low, ultra quiet sleep mode
3 = high
3. Select UV-C ON or OFF using UV-C Mode Button.
*Filter Replacement Indicator: The Replace HEPA light on the control panel will
illuminate and flicker indicating that it is time to replace your filter. Replace the filter
according to directions (E-6) then press and hold the UV Mode button for 3 seconds to
reset the system.
*UV Bulb Replacement Indicator: The circular blue light on the front panel of the purifier will
flicker when it’s time to replace the bulb. Replace the bulb according to directions (E- 8), then press
and hold UV Mode button for 3 seconds to reset the system.
E-6 E-7
INSTALLING & REMOVING COMBINATION FILTER
2. Press the Lock & Release
Button and remove the
Rear Cover from the unit.
3. Remove the used
Combination Filter (Filter C)
and dispose of it in
the garbage.
4. Insert filter system into the unit.
Consult the arrow on the filter
for correct installation direction.
5. Reattach the Rear Cover of the unit and securely latch into place.
1. Turn off and unplug the unit.
The Air Cleaner will beep for 30 seconds and the Replace HEPA light will flash
continuously indicating that it is time to replace your filter. Replace the filter
according to directions then restart the system. See specific model instructions
(E-7/E-8). Depending on usage, filter will last approximately 6 months.
OPERATING INSTRUCTIONS
To Next Page
Loading...
Need help?
General
