Guardian AirSafe+ AC3000 User Manual

OPERATING INSTRUCTIONS
BEFORE OPERATING THE AIR PURIFIER
1. Select a firm, level and flat location for the air purifier.
« For proper air flow, locate the unit at least 1 foot from any wall or furniture.
* Make sure none of the grills are blocked.
2. Plug the power cord into a 120V AC outlet.
OPERATING THE AIR PURIFIER
UVC Reset
. Power Button Operation - Press the power button: Press 3.
ONCE to turn the unit on and to put into auto mode.
The Auto Mode indicator on the control panel will turn on.
TWICE to enter speed one. The low fan speed indicator
on the control panel will turn on.
THREE times to enter speed two. The medium fan speed
indicator on the control panel will turn on. G—es
" . 0,7 N
FOUR times to enter speed three. The high fan speed S J
indicator on the control panel will turn on. \
FIVE times to enter sleep mode. The air quality monitor
on the front of the unit will flash for 10 seconds, all lights \ /
will turn off, and the air purifier will run in low fan speed. .
SIX times to power the unit off. oFitter Reset
2. UV-C - Press the UV-C button to turn on the UV-C light.
When the UV-C light is on the button will illuminate.
To tum off the UV-C, press the button again.
What is Auto Mode?
When in auto mode the fan speed will change depending on the air quality level in the room.
If the AQM detects higher particle levels, the air purifier will kick into a higher fan speed.
After the air quality has improved, it will lower the speed. You can leave the air purifier in
auto mode 24/7 for best results.
To exit auto mode press the power button again to cycle through the remaining speed levels.
What is Sleep Mode?
In sleep mode the air purifier will run at Speed One with no lights while still filtering the air.
To exit sleep mode, press the power button again and the unit will shut off.
E6

Guardian AirSafe+ AC3000 Specifications

General

Brand	Guardian
Model	AirSafe+ AC3000
Category	Air Cleaner
Language	English