Owner’s Manual
Please read and understand this manual and safety instructions carefully before installation.
The Opener WILL NOT CLOSE until the Photo Eye Safety System is properly installed and aligned.
REGULARLY CHECK and TEST the Opener according to the safety label to ENSURE SAFE OPERATION.
Retain this manual for future reference.
Serial # __ __ __ __ __ __ __ Date Installed __ __ /__ __ /__ __ __ __
WARNING:
To reduce the risk of injury to persons - Use this operator only with Residential Sectional Garage doors.
Located on the label on top of your opener.
The illustrations used in this instruction manual may differ from the actual product you have purchased.
WARNING:
To reduce the risk of injury to persons - Use this
operator only with Residential Sectional Garage
doors.
Owner’s Manual
• Please read and understand this manual and safety instructions carefully before installation.
• The Opener WILL NOT CLOSE until the Photo Eye Safety System is properly installed and aligned.
• REGULARLY CHECK and TEST the Opener according to the safety label to ENSURE SAFE OPERATION.
• If using the unattended operation feature, use ONLY with sectional doors.
• Retain this manual for future reference.
• *In California: To be in compliance with CA SB-969, this operator must be installed with the backup battery kit, STDBBUKIT.
Serial # __ __ __ __ __ __ __ Date Installed __ __ /__ __ /__ __ __ __
Located on label on top of your opener.
GDO Manual Revised: 05-24 GDOMU15A-11
MODEL 7160V
PRO Series
Chain Or Belt
Drive
Works with the beam
Smart Controller
To Next Page
Need help?
General
