Replacement parts (Available from Guest Co. see last page for contact information)
Item Part #
Replacement 100 Watt bulb kit 729493
Dual station control panel (or replacement
wireless control panel)
729825
Base mounting gasket 728377
Gasket for lens B-23131
Troubleshooting
Under normal use, your Guest Beamer spotlight will provide you with many years of
reliable service. If your unit should become damaged by a severe impact, we
recommend that you Contact Guest Company. (See last page) for technical support
and parts information.
If an operational problem occurs:
1. Confirm that all fuses are intact. If a fuse has blown, do not replace the fuse
until the cause of the problem has been located and corrected. NEVER replace a
blown fuse with a higher value fuse.
2. Most problems are caused by poor wiring connections. Confirm that all wiring
connections are accurate and well made. The connections of the wires are
important and should be soldered and then taped, or connected using
weatherproof phone splices. Be sure that the spotlight is connected to a DC power
source capable of supplying at least 12 volts at 10 amps even while other
equipment is operating.
3. If the spotlight does not move or light:
a. Observe the control panel. The Red light on the control should turn on
whenever a button is pressed. If it does not, first check the (internal battery), if
correct then replace the control panel.
b. Disconnect the 12 Volt Dc power from the spotlight. Reconnect the 12-volt DC
power from the spotlight. Press the “green” power button 2-3 times with in 5
seconds of applying power to the light.
c. Remove the 4 bolts that fasten the spotlight onto the mounting surface and
gently lift the unit until you can see inside its base. Avoid cutting any wires.
Gently inspect the wiring inside the base for broken connections. Examine the
circuit board for loosened plug connectors, blackened components or
corrosion. Replace the circuit board if it appears damaged. If there are no
To Next Page
Loading...
Need help?
General