13 of 15
INSPECTION AND MAINTENANCE SCHEDULE
Complete the following before each and every use
[ ] Inspect all webbing, rope, cord, and strap assemblies for wear or damage.
[ ] Inspect for any structural damage to product. (If any exists stop use immediately and contact
the manufacture at 844-688-0690 or email support@sourceoneint.com)
[ ] Inspect all nut and bolt assemblies to ensure none have become loose. Use correct size
wrenches when adjusting or tightening nuts/bolts. Exercise care when tightening nuts/bolts to
ensure tubing does not become damaged OR crushed!
[ ] Inspect for any structural damage OR missing parts. Pay close attention to any/all weld and
joint locations. (Return to factory for repair or discard product if any damage is found.)
[ ] Inspect seat,arm rest and padded shooting rest for damage or wear. Replace any seat,arm
rest or shooting rail pads if found damaged or worn with new from manufacturer.
Complete the following checklist at least once per year
[ ] Inspect and check operation of all cord, rope, webbing, and strap assemblies. Replace with
manufacturer original replacement parts any item or assembly that shows signs of wear, damage,
kinking, or functions incorrectly.
[ ] Lubricate all pivot and slide together points with powder graphite to help prevent noise, wear,
and rust.
[ ] Inspect entire product for any rust,corrosion,cracks, freezing,excessive heat or rotting that
may effect the safety of your product. Discard or replace any questionable product.
* Return to factory or discard product if any damage is found that could weaken
the structural integrity of the stand and/or cause potential harm to the user.
To Next Page
Loading...