8
2
Operating Instructions
3. VARIABLE SPEED CONTROL DIAL (SEE FIG C)
Adjust the variable speed control dial (2) to increase or decrease the speed according
to the material and sanding belt specification to be used (also possible during no
load operation). See the table below for general guidance on speed selection. Avoid
prolonged use at very low speed as this may damage your sander’s motor.
Material Speed selection Belt Grit
Solid Wood 5-6 80
Veneer 2-4 150
Chipboard 1-5 60/80
Plastics 2-5 100
Steel 5-6 80
Paint Removal 6 40/60
Balsa Wood 1-3 100
Acrylic 1-2 100
4. HAND GRIP AREAS (SEE FIG D)
Always hold your belt sander firmly with both hands when operating.
C D
C3
To Next Page
Loading...