Section 3
3-11
3.5.5.2. Function - <Select>
Pressing the <Select> key will cause one of the currently selected items or the first
item in a list to be highlighted. The cursor arrow keys can then be used to move the
highlight from selection to selection on the screen.
If the screen type is a selection screen, for example the <Resistor select menu
function>, the highlighted item will be selected active, only when the soft function
key <Ok> is pressed.
While in an <Edit screen function>, the highlighted item can be modified by using
direct entry from the numeric key pad. If the cursor movement <left/right arrow>
keys, or <CLEAR> key have not been pressed then any numeric entry will clear the
current line and display the pressed key at the cursor position. Pressing any one of
the cursor movement keys will cause the current character under the cursor to be
replaced with the next numeric key pressed.
The <CLEAR> key, when editing data will clear the current data.
3.5.5.3. Function - <Ok>
Pressing the soft function <Ok> key will either load the item selected or accept all
the changes that have been made in the current menu (including the screens not
currently displayed if there are multiple screens).
At any time before pressing the <Ok> key, the <CANCEL> key can be pressed to
undo all changes that have been made.
To Next Page
Loading...