Section 3
3-22
3.7.2.2.1.1. <Mode> MENU Fn-1 (Edit_Resistors_Setup_MAIN)
▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒
▒Mode: <Fn-??> RS : ▒
▒Display: RS SN: ▒
▒Update: RX : ▒
▒Filter: RRate: ▒
▒Power: Ratio: ▒
▒ ▒
▒══════════╤══════════╤═════════┬──────────▒
▒4 Terminal│2 Terminal│I Extend │ ▒
▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒
Function key <Fn-1>, <4 Terminal>, will select the 4-terminal measurement
mode of operation.
Function key <Fn-2>, <2 Terminal>, will select the 2-terminal measurement
mode of operation.
Function key <Fn-3>, <I Extend>, will select operation using a high current
range extender for low value resistance measurements.
3.7.2.2.1.1.1. <4 Terminal> MENU Fn-1
(Mode_Edit_Resistors_Setup_MAIN)
Enter configuration for 4-terminal resistance mode measurements.
▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒
▒Resistance RS: ▒
▒Serial No. RS: ▒
▒Resistance RX: ▒
▒Reversal Rate: ▒
▒Test Current (mA): ▒
▒Max Current (mA): ▒
▒──────────┬──────────┬─────────┬──────────▒
▒Edit │Ok │ │ ▒
▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒
Press <Edit> and use arrow keys to move the highlight to the data line to be changed.
Modify data and press <Ok>. Check resistance limits for Rs and Rx. Check also
power limits set by test current.
Where the Test Current (I(test) Ix) sets the current in the UNKNOWN
RESISTOR (Rx).
To Next Page
Loading...