Section 3
3-35
Voltmeter function menu selection screen 2 of 2
▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒
▒STATUS LINE ▒
▒ ▒
▒ ▒
▒Voltmeter Reading ▒
▒ ▒
▒ ▒
▒──────────┬──────────┬─────────┬──────────▒
▒Cal_Ch Off│Chart Off │ │MORE 2-2 ▒
▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒
Cal_Ch +FS Chart On
Cal_Ch 0
Cal_Ch -FS
Function Key <Fn-1> ,<Cal_Ch off>, allows selection of the value of the chart recorder
output. Where:
<Cal_Ch Off> leaves the value of the chart recorder output unchanged
<Cal_Ch +FS> sets the chart recorder output to maximum positive voltage
<Cal_Ch 0> sets the chart recorder output to zero output voltage
<Cal_Ch -FS> sets the chart recorder output to maximum negative voltage.
Function Key <Fn-2> ,<Chart Off>, allows selection between turning the chart recorder
output on or off. The values will be scaled depending on the values set in the
<Sofcal><Chart> menu. The datum will either be the value displayed when the chart
recorder output was turned on, or the value set in the previous <Voltmeter> menu screen by
the function key <Fn-3> ( <Delta> or <Delta SP>).
To Next Page
Loading...