Manual Override - Inside Frame
Locate the hex head crank extension at the top of the actuator
inside the chassis main frame. Using a 3/4 socket and ratchet,
rotate the extension clockwise to retract the slide-out and counter
clockwise to extend the slide-out. It is important to note that you DO
NOT need to attempt to disengage the motor as the actuator is
“manual ready.”
NOTE: Use EXTREME CAUTION when extending and/or retracting
room using the manual override feature. It is possible to operate the
slide-out beyond the maximum extension and/or retraction and
damage the slide components, slide room structure or trim
components.
NOTE: The gears can be stripped out if the room is manually
retracted/extended to its fullest extent and the operator continues to
rotate manual override. Any damage due to misuse of the Manual
Override feature will disqualify any and all claims to the Limited
Warranty.
Electrical System Maintenance
For optimum performance, the slide-out system requires full battery
current and voltage. The battery MUST be maintained at full
capacity. Other than good battery maintenance, check the terminals
and other connections at the battery, the control switch, and the
system for corrosion, and loose or damaged terminals. Check
motor leads under the trailer chassis. Since these connections are
subject to damage from road debris, be sure they are in good
condition.
To Next Page
Loading...