Gulfstream G200 - Trim Systems Controls and Indicators; Pitch Trim Controls; Horizontal Trim Override; Aileron and Rudder Trim Switches

TRIM SYSTEMS CONTROLS AND INDICATORS
Pitch Trim Switches (2) - Located on each outboard prong of pilot and
copilot control wheels. The switches have three positions:
Center - Stops horizontal stabilizer trim operation.
NOSE DOWN - Momentary position to trim nose down. Spring
loaded to center.
NOSE UP - Momentary position to trim nose up. Spring loaded to
center.
NOTE
Pilot pitch trim switch has priority over copilot
switch.
PITCH TRIM REL. Button - Located on pilot control wheel inboard
prong. Pressing the button deactivates normal system
and arms OVRRD system; RESET OVRRD button light
comes on.
HORIZ TRIM OVRRD Switch - Controls the override trim system in the
same manner the normal pitch trim switches control the
normal system.
RESET OVRRD Button - When pressed, the override system is
de-energized and normal system is armed. It lights up
when PITCH TRIM REL. button is pressed.
AILERON Trim Switch - Has three position as follows:
Center - Stops aileron trim operation.
RW DN - Momentary position. Moves control wheel to right (right
roll).
LW DN - Momentary position. Moves control wheel to left (left roll).
Gulfstream G200 - Trim System
Page 4