1 1 & 2 fasten rectangular L racket (plate) with bolts provided.
2 Put the screws into the rectangular plate.
3 Once rectangular plate is fixed to the frame; the next step is to install the armrests
4 Bolts go through bottom-rear of armrest bracket, then secured with nuts.
5 The seat frame and armrest installation is finished.
POWER-UP
POWER-DOWN
stop power on controller
5.To adjust the back simultaneously
Press and hold button to recline/ button to incline. See table page.10
for controller function.
WARNING:DO NOT EXERT ANY PRESSURE OTHER THAN YOUR OWN WEIGHT
ON THE BACK WHILE IT IS RISING.
Hook & loop ribbon
To Next Page
Loading...
