What to do if there is no sound from Gutermann Measuring Instruments?
If you are experiencing no sound, there might be several reasons. First, ensure that your BT headphones are properly paired. If they are, check the headset volume control and increase it if it's too low. Finally, make sure your BT headset is adequately charged; charge it regularly, similar to how you would charge a mobile phone.
Why is there no radio connection to sensors on Gutermann Measuring Instruments?
If there is no radio connection to the sensors, it could be due to low battery on the sensors. Charge the sensors using the car charger. Alternatively, the sensors might be turned off, so ensure that you switch them on.
What to do if Gutermann AQUASCAN 610 correlation doesn’t stop processing?
If the correlation doesn’t stop processing, it's possible that the correlation settings are on infinite. You should change the correlation settings or manually stop the correlation.
Why Gutermann AQUASCAN 610 Measuring Instruments result is 0 or negative?
A result of 0 or negative may occur if the leak noise originates from a leaking hydrant on which the sensor is placed, or beyond the sensor. In this case, fix the hydrant or move the sensor to bring the leak within the bracket.
Why Gutermann AQUASCAN 610 Measuring Instruments leak result is out by several meters?
If the leak result is off by several meters, the incorrect velocity may be to blame, due to the wrong pipe material or age of pipe being entered. Perform a velocity check to resolve this.
How to fix poor correlation spectra on Gutermann AQUASCAN 610 Measuring Instruments?
Poor correlation spectra can result from poor sensor or radio contact. Try repositioning the sensors, cleaning the magnet contact area, or fitting an antenna extension cable.
What to do if Gutermann AQUASCAN 610 leak result is on a Tee section?
If the leak result is on a Tee section, the leak could be up the branch of the Tee section. Try moving the sensor to the next section of the Tee.
How to resolve Centre Correlation issues with Gutermann AQUASCAN 610 Measuring Instruments?
If you are experiencing centre correlation issues, it might be due to the sensors being on different pipes. Move the sensors to the same pipe. This issue may also occur with parallel mains, so ensure the sensors are on the same pipe in that situation as well.
What causes corrupt display on Gutermann AQUASCAN 610 Measuring Instruments and how to fix it?
A corrupt display is caused by memory corruption. To fix it, clear the memory.
What to do if no display of correlator on Gutermann AQUASCAN 610 Measuring Instruments?
If there is no display of the correlator, the batteries are likely dead. Charge the unit.
General| Brand | Gutermann |
|---|---|
| Model | AQUASCAN 610 |
| Category | Measuring Instruments |
| Language | English |
To Next Page
