EN
64
Item Meaning
Change-
ble
Value
Format
Remark
U2 Volume for
button tones
0…3 Adjustment of the volume for button
tones
0: no button tones
1: min. volume
2: mid. volume
3: max. volume
Notes:
For normative reasons, button tones for swit-
ching ON and OFF cannot be disabled. They
will be emitted with last volume level which
has been set before disabling the button to-
nes.
Tones for errors are always emitted with max.
volume (setting 3) and cannot be disabled.
U3 Volume for
signal tones
Yes 0…3 Adjustment of the volume for signal tones
( e. g. when timer runs out )
0: min. volume
...
3: max. volume
U4 Display
brightness
0…9 Adjustment of the brightness for the display
0: Max. brightness
....
9: Min. brightness
U5 Timer
animation
0…1 0: No Timer animation
1: Timer is animated 10 min before expiration
U6 Permanent pot
detection
Yes 0…1 0: permanent pot detection not active
1: Permanent pot detection active
U7 Behaviour
when timer
has run out
Yes 0…2 0: Signal tone for 120 sec
1: Signal tone for 10 sec
2: No tone
OPERATION MANUAL
To Next Page
Loading...
