Guyson 2 - Page 40

Operation &
Maintenance
Manual
Issue:
10
A6ML0066 – Euroblast SF Instruction Manual
Date:
05/2019
Page: 40
C400, C600 and C800 dust collectors are fitted as standard with differential pressure gauges. These
measure the differential pressure across the main filter(s). When the pressure difference reaches 5”
Water Gauge then a filter change will be necessary. The HEPA 14 filter (where fitted) has a separate
gauge. When this reaches 2.5” Water Gauge then a filter change will become necessary. See
sections 7.1.10.4 and 7.1.10.5 for details.
The 41 dust collector does not come fitted with differential pressure gauges as standard. Hosetails
are fitted as standard allowing an aftermarket differential pressure gauge (E1AA1836) to be used.
On a 41 dust collector, after approximately five hundred hours use the dust will have worked its way
into the body of the filters and cleaning with the cleaning mechanism will no longer clean sufficiently to
allow enough air through. This will be evident by poor visibility in the cabinet and/or failure to extract
the dust even with the dust collector damper fully open. A filter change will be necessary at this point.