Need help?Do you have a question about the GW Instek GDS-320 and is the answer not in the manual?
General| Bandwidth | 200 MHz |
|---|---|
| Channels | 2 |
| Sample Rate | 1 GSa/s |
| Vertical Resolution | 8 bits |
| Timebase Range | 2.5 ns/div to 50 s/div |
| FFT | Yes |
| Maximum Input Voltage | 300 V (DC + AC peak) |
| Display | 8-inch color LCD |
| Input Impedance | 1 MΩ |
| Vertical Sensitivity | 1 mV/div to 10 V/div |
| Trigger Modes | Edge, Pulse, Video |
| Waveform Update Rate | 100, 000 wfm/s |
| Math Functions | +, -, x, /, FFT |
| Automatic Measurements | Rise Time, Fall Time |
| Interfaces | USB Host, USB Device, LAN |
| Waveform Capture Rate | 100, 000 wfm/s |
| Power Supply | AC 100V ~ 240V, 50/60Hz |
Explains the main elements and layout of the instrument's display.
Explains basic gestures and interface conventions for touch control.
Guides through powering up, driver installation, and basic settings.
Details basic touch gestures for operating the instrument.
Covers vertical scale, position, and channel settings via the vertical menu.
Explains how to access and use the trigger menu for waveform capture.
Details trigger types like Edge, Pulse Width, and Video.
Describes the Run, Stop, and Single modes for waveform acquisition.
Explains Go-NoGo tests for boundary checks and template creation.
Explains how to use the Digital Multimeter function simultaneously with the DSO.
Presents detailed technical specifications for the oscilloscope and multimeter.
To Next Page
