ELECTRICAL SAFETY TESTER
USER MANUAL
21
4. Use FIELD key to change active parameter.
5. Repeat step 3 and 4 to adjust parameter.
6. After setting all parameters, press EDIT/SAVE key to save the step.
The status will become SAVE. After the step is saved, the status will
return to EDIT.
7. Repeat the procedure “To View the Storage Steps” to select another step.
FIELD
V
=
2
.
0
0
0
k
V
EDIT/SAVE
S
A
V
E
ELECTRICAL SAFETY TESTER
USER MANUAL
22
z To Begin a Group Test
1. Repeat the procedure “To View the Storage Steps” to select a step.
2. Press RESET button to enter status READY.
3. Make sure the test environment is safe.
4. Press START button to start the test while the status TEST is active
and the CAUTION LED flashes.
START
T
E
S
T
R
E
A
D
Y
RESET
To Next Page
Loading...
