COMMAND OVERVIEW
21
Status
:STATus:CHANnel:CONDition? ............................... 105
:STATus:CHANnel:ENABle....................................... 106
:STATus:CHANnel:EVENt? ....................................... 106
:STATus:CHANnel:NTRansition/PTRansition ......... 107
:STATus:CSUMmary:ENABle ................................... 108
:STATus:CSUMmary:EVENt?.................................... 109
:STATus:QUEStionable:CONDition? ....................... 109
:STATus:QUEStionable:ENABle ............................... 110
:STATus:QUEStionable[:EVENt]? ............................. 110
:STATus:QUEStionable:NTRansition/PTRansition . 111
:STATus:PREset ........................................................ 112
Voltage
:VOLTage:L1/L2 ........................................................ 113
:VOLTage:AVALue/BVALue ...................................... 114
:VOLTage:CURRent .................................................. 115
:VOLTage:MODE ...................................................... 116
System
:SYSTem:ERRor? ....................................................... 117
:SYSTem:VERSion? ................................................... 117
Memory
:MEMory:SAVE:PREset ............................................. 118
:MEMory:SAVE:PROGram ........................................ 118
:MEMory:SAVE:ALLPreset ........................................ 119
:MEMory:SAVE:SETup .............................................. 119
:MEMory:RECall:PREset ........................................... 119
:MEMory:RECall:PROGram ...................................... 120
:MEMory:RECall:ALLPreset ...................................... 120
:MEMory:RECall:SETup ............................................ 120
PEL-2000 Programming Manual
22
Sequence
:SEQuence:EDIT:POINt............................................. 122
:SEQuence:END ........................................................ 123
:SEQuence:POINt:RESistance ................................... 123
:SEQuence:POINt:CURRent ...................................... 124
:SEQuence:POINt:RISE/FALL ................................... 124
:SEQuence:POINt:TIME ............................................ 125
:SEQuence:REPeat ..................................................... 126
:SEQuence:END:LOAD ............................................. 126
:SEQuence:VOLTage:RANGe .................................... 127
:SEQuence:LOOP:STARt ........................................... 128
:SEQuence:CHANnel:TIME ....................................... 128
:SEQuence:RUN ........................................................ 129
:SEQuence:SAVE........................................................ 129
To Next Page
Loading...