SFG-2000 Series User Manual
6
Safety Guidelines
• Do not place any heavy object on SFG-2000 series.
• Avoid severe impacts or rough handling that leads to
damaging SFG-2000 series.
• Do not discharge static electricity to SFG-2000 series.
• Use only mating connectors, not bare wires, for the
terminals.
• Do not block or obstruct cooling vent opening.
• Do not perform measurements at power source and
building installation site (Note below).
• Do not disassemble SFG-2000 series unless you are
qualified as service personnel.
General Guideline
CAUTION
(Note) EN 61010-1:2001 specifies the measurement categories and
their requirements as follows. SFG-2000 series falls under category
II.
• Measurement category IV is for measurement performed at the
source of low-voltage installation.
• Measurement category III is for measurement performed in the
building installation.
• Measurement category II is for measurement performed on the
circuits directly connected to the low voltage installation.
Power Supply
WARNING
• Input voltage: 115/230V AC +10%, −15%, 50/60Hz
• The power supply voltage should not fluctuate more
than 10%.
• Connect the protective grounding conductor of the
power cord to earth ground, to avoid electrical shock.
Fuse
WARNING
• Fuse type: T0.125A/ 250V
• Only service personnel are allowed to access internal
fuse holders.
• Replace the fuse with the specified type and rating
only, for continued fire protection.
• Disconnect the power cord before fuse replacement.
• Make sure the cause of the fuse blowout is fixed
before fuse replacement.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
