11
GYSPACK AUTO / 400 / 600
EN
Translation of the original instructions
• Wear safety goggles and protective gloves
• If your eyes or skin come into contact with bat-
tery acid, rinse the affected part of the body
with plenty of water and seek immediate medi-
cal assistance.
Connection:
• Class II device (charger booster)
• Class III device (booster)
Connection to the mains must be made accor-
ding to the national installation regulations.
Maintenance:
• The power supply cable cannot be replaced. If
the cable is damaged,the device should not be
used.
• Service should be performed by a qualified per-
son
• Warning! Always disconnect from the mains
before performing maintenance on the device
(charger & booster).
• If the internal fuse is blown, it must be replaced
by the manufacturer, its after-sales service or an
equally qualified person.
• Under no circumstances should solvents or other
aggressive cleaning agents be used.
• Clean the device’s surfaces with a soft, dry cloth.
Regulations:
• The device complies with European Directive.
• The certificate of compliance is available on our
website.
• EAC conformity mark (Eurasian Economic
Commission)
• Equipment in conformity with Moroccan
standards.
• The declaration Cم (CMIM) of conformity is
available on our website (see cover page).
To Next Page
Loading...
